VCS VideoJet 8000 User Manual page 110

Configuration using a Web Browser
After the upload is completed successfully, the unit will restart automatically.
If the Failure LED is blinking, the upload has failed and must be done again. To
perform the upload, you must go to a special page.
– In the address field of the browser, append /main.htm to the IP address of
the unit (e.g. 192.168.0.80/main.htm) and hit return.
– Repeat the upload.
Configuration download:
The VideoJet 8000 configuration data can be saved on a computer and the saved
data loaded on a unit from the computer.
– Click Download. A dialog will appear.
– Follow the instructions to save the current settings.
Configuration upload:
– Enter the full path of the file to upload or click Search to select the desired file.
– Make sure that the file to be loaded comes from a VideoJet 8000.
– Click Upload to begin transmitting the file to the unit.
This message will appear: Configuration upload finished. Status: Configu-
ration upload OK. (system must be rebooted) will be displayed and the
countdown for the reconnection will be shown.
The next time the Software update page is opened, the message Configuration
upload OK confirms that the upload was successful. The message Configu-
ration upload failed indicates that the file did not load properly (perhaps the file
specified was not from the same type of device). Repeat the upload and use
another file if necessary.
Note
The new configuration will be active after the VideoJet 8000 is restarted.
Enter the current IP address followed by /reset.
110
Chapter 5
VideoJet 8000