Size Adjustment; What Can Be Done; Start Up; Hint - Barco R9002380 Owner's Manual

Start up

To correct the Seagull Correction :
1. Push the cursor key é or ê to highlight SEAGULL CORRECTION (menu 1)
2. Press ENTER to activate.
Eliminate the deformation by pushing the cursor key é or ê until a straight line is obtained (image 1).
TOP-BOTTOM (N-S)
H CENTERLINE BOW
H CENTERLINE SKEW
TOP KEYSTONE
TOP BOW
BOTTOM KEYSTONE
BOTTOM BOW
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1

Size Adjustment

What can be done ?

To adjust (correct) a little bit the picture size (when the projector is on its correct position) in regard with the installed screen
Start up
1. Push the cursor key é or ê to highlight Size (menu 1).
2. Press ENTER to activate (menu 2).
1. Push the cursor cursor key è or ç until the exact image width is obtained (horizontal size) (image 1).
2. Push the cursor key é or ê until the exact image height is obtained (vertical size) (image 2).
Note :
- If the internal # pattern was selected, this pattern remains on the screen.
- If the genlocked pattern was selected, the external source will be displayed.
A bar scale and a numeric indicator help to gauge the size adjustment.

Hint

In order to avoid loss of resolution in the projected image and to ensure maximum CRT longevity, do not use an excessively small
horizontal size setting.
GEOMETRY
H PHASE
RASTER SHIFT
LEFT-RIGHT (E-W)
TOP-BOTTOM (N-S)
V LINEARITY
BLANKING
Select with or
then <ENTER>
<EXIT> to return.
menu 1
H size too
large
H size too
small
image 1
5976066 BARCOCINE 7 07022000
image 1
menu 2
Ideal image width
H SIZE
70
Ideal
Image too
Image
Tall
Hight
image 2
Random Access Adjustment Mode
Ideal
Image too
Image
Hight
Short
7-17