Factory Preset; Geometry Adjustments; What Can Be Done; Start Up - Barco R9002380 Owner's Manual

Factory Preset

What can be done ?

All settings for the line multiplier can be set to factory preset settings.
What are the factory preset settings ?
The factory preset settings are :
Time base correction : on
Luminace delay : 0
Vertical sync reference : indirect
Clamp gating : off
How to activate ?
1. Push the cursor key é or ê to select 'Factory Preset' (menu 1).
2. Press ENTER to activate.
LINE MULTIPLIER
TIME BASE CORRECTION : ON
LUMINANCE DELAY
V SYNC REF : INDIRECT
CLAMP GATING : OFF
WARNING : ADVANCED
ADJUSTMENT SHOULD BE
PERFORMED ONLY BY QUALIFIED
PERSONNEL
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1

Geometry Adjustments

What can be done ?
The geometry adjustments have to be done only on the green image. These adjustments are automatically implemented for the other
color images. The following adjustments can be adjusted Left-right (EW) and Top-Bottom Corrections, Blanking, Horizontal Amplitude,
Vertical Amplitude, Vertical Linearity and Horizontal Phase.

Start Up

To start up the geometry corrections, handle as follow :
1. Push the cursor key é or ê to highlight 'Geometry' (menu 1).
2. Press ENTER to select.
The Geometry menu will be displayed on the screen (menu 2).

Important

The convergence corrections are disabled during geometry corrections. The blanking corrections are only enabled during the
blanking adjustments.
RANDOM ACCESS
ADJUSTMENT MODE
PICTURE TUNING
CONVERGENCE
COLOR SELECT
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
5976066 BARCOCINE 7 07022000
GEOMETRY
H PHASE
RASTER SHIFT
LEFT-RIGHT (E-W)
TOP-BOTTOM (N-S)
SIZE
V LINEARITY
BLANKING
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 2
Random Access Adjustment Mode
7-11