Projector Set-Up; What Can Be Done; Start Up The Projector Set-Up; Identification - Barco R9002380 Owner's Manual

Service Mode

Projector Set-up

What can be done ?

Within the projector set-up menu, the following items can be consultated or set to the
desired setting :

- Identification

- Total run time
- Change password
- Change language
- Change projector address
- Change baudrate
- Power up mode
- BARCO logo

Start up the Projector Set-Up

To select Projector Set-Up :
1. Push the cursor key é or ê to highlight Projector Set_Up (menu 1).
2. Press ENTER to display the Projector set up menu (menu 2).
SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
Identification

What can be seen ?

The 'Identification' screen gives information concerning :
- Projector address. To change the address of your projector, contact a qualified service technician.
- Software version.
- Configuration.
Possible installations :
* Front-ceiling
* Front-table
* Rear-ceiling
* Rear-table
- Baud rate PC : transfer speed for communication with an IBM PC (or compatible) or MAC. The baud rate of the projector must be
the same as the baud rate of the connected computer. When there is a difference, contact a qualified service technician to make
the appropriate changes.
- Text ON/OFF
Indicates in operational mode if the bar scale and number indicator will be displayed and if warnings and failures will be dis-
played.
ON : displayed
OFF : not displayed
The status can be changed by pressing the 'TEXT' key once on the RCU.
- Serial no. : indicates the fabrication number of the projector. This number can be useful when calling for technical assistance.
8-2
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
COMMON ADDRESS : 0
BARCO LOGO
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 2
5976066 BARCOCINE 7 011299