Wait For Start To Feed; Automatic Start To Feed - Böwe Bell + Howell truper 3200 Operator's Manual

Wait for Start to Feed

In this mode, the operator can manually control the start and stop of a batch using the STOP/START
button. To exit the feed mode, press the scanner's STOP/START key and cancel scanning from the
application.
1. Select Start Button from the Manual Feed Mode drop-down list.
2. Click the Start Batch button (or button with similar name). The scanner will not start feeding
as it is waiting for the STOP/START button.
3. Load the document(s) under the paper feed roller.
4. Press the STOP/START button to begin scanning
The scanner will start scanning and will continue until the feeder is empty or the operator
presses the STOP/START button to stop the batch.
5. During the scan operation, press the STOP/START button to stop scanning. This is not an
emergency stop. The scanner will complete scanning of the document and then stop prior to
feeding the next document.
With this setting activated, the operator manually controls the scanner start and stop document
feed operation. Continue steps 2, 3 and 4 until you are ready to close your batch with the scanning
application.

Automatic Start to Feed

Use this mode to drop the ADF tray between each batch and to restart scanning immediately.
1. Set the feed selector switch to AUTOMATIC. The feeder will adjust automatically to the
automatic feed position.
2. Click the Start Batch button (or button with similar name) in the scanning application. Place
your documents into the feeder tray. As the lead edge of the document batch comes close to
the feed rollers, the ADF tray will come up and the paper feed rollers will automatically feed
the batch of documents in the scanner.
www.bbhscanners.com
65 of 150