Set/Define Server Name; Set/Define Server Nameserver - Lantronix ETS Reference Manual

Command Reference

12.46.23 Set/Define Server Name

SET
SERVER NAME ServerName
DEFINE
Specifies the name of the ETS.
Applies To
Restrictions
Parameters
The ETS name string must be enclosed in quotes to preserve case.
Note:
See Also

12.46.24 Set/Define Server Nameserver

SET
SERVER SECONDARY NAMESERVER IPaddress
DEFINE
Specifies the IP address of the name server used for TCP/IP connections, if any. This host will attempt to
resolve text Telnet hostnames into numeric form if the local host table cannot do so.
Applies To
Restrictions
Parameters
Examples
See Also
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
You must be the privileged user to use this command.
ServerName
Enter a string of up to 16 alphanumeric characters.
Show/Monitor/List Server, page 12-108; Changing the Server Name, page 3-5.
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
You must be the privileged user to use this command.
Secondary
Allows you to specify a backup nameserver for when the primary nameserver
is unavailable.
IPaddress
Enter the network address of the nameserving host in standard numeric IP
format. Specifying "0.0.0.0" as the address clears the previously-defined
nameserver.
Local> SET SERVER NAMESERVER 192.0.1.49
Local> SET SERVER SECONDARY NAMESERVER 192.0.1.34
Define Protocols IP, page 12-57; Show/Monitor/List Protocols IP, page 12-
104; TCP/IP, page 2-7; Editing the Boot Parameters, page 3-7; Other TCP/IP
Parameters, page 4-5.
Set/Define Server Commands
12-73