Set Gateway Ip Address; Netmask: Number Of Bits For Host Part; Set Dns Server Ip Address; Change Telnet/Web-Manager Password - Lantronix xPico User Manual

Set Gateway IP Address

The gateway address, or router, allows communication to other LAN segments. The
gateway address should be the IP address of the router connected to the same LAN
segment as the unit. The gateway address must be within the local network. The
default is N (No), meaning the gateway address has not been set. To set the gateway
address, type Y and enter the address.

Netmask: Number of Bits for Host Part

A netmask defines the number of bits taken from the IP address that are assigned for
the host part.
Note: Class A: 24 bits; Class B: 16 bits; Class C: 8 bits
The unit prompts for the number of host bits to be entered, then calculates the
netmask, which appears in standard decimal-dot notation (for example,
255.255.255.0) when the saved parameters display.
Network Class

Set DNS Server IP Address

The DNS server allows the name of a remote machine to be resolved automatically.
The default is N (No), indicating the DNS server address has not been set. To set the
DNS server address, type Y. At the prompt, enter the DNS server address. If the
device is DHCP enabled, the DHCP server provides the DNS server IP address,
which will override this configured value.
Note: This setting is applicable only in Manual Connection mode.

Change Telnet/Web-Manager Password

Setting the Telnet/Web-Manager password prevents unauthorized access to the
setup menu through a Telnet connection to port 9999 or through web pages. The
password must have 4 characters.
xPico User Guide
Set Gateway IP Address (N) ? Y
Gateway IP addr ( 0) ( 0) ( 0) ( 0)_
Netmask: Number of Bits for Host Part (0=default) (0) _

Table 6-2. Standard IP Network Netmasks

Host Bits
A
B
C
Set DNS Server IP addr
Change Telnet/Web-Manager password (N) ? _
6: Setup Mode: Server Configuration
Netmask
24 255.0.0.0
16 255.255.0.0
8 255.255.255.0
<N> ?
38