Set/Define Port Autoconnect - Lantronix ETS Reference Manual

Command Reference
Errors
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Examples
See Also

12.43.4 Set/Define Port Autoconnect

SET
PortList
PORT
DEFINE
ALL
Connects a port automatically to the preferred service (LAT or Telnet) upon login. You can still Break to
local mode and use the Connect command to attach to other services. Autoconnect is disabled if there is no
preferred service defined. Also, if both preferred LAT and preferred Telnet services have been set, the LAT
connection will be attempted.
Applies To
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Examples
See Also
Autobaud will not work for all parity/baud combinations—it will only function
if the port is using either 8-bit characters with no parity or 7-bit characters with
even parity, and for baud rates from 1200 through 38400.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Local> DEF PORT AUTOBAUD DISABLED
Define Port Access, page 12-27; Set/Define Port Speed, page 12-51; Show/
Monitor/List Ports, page 12-102; Baud Rates, page 5-8.
ENABLED
AUTOCONNECT
DISABLED
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Local> SET PORT AUTOCONNECT ENABLED
Set/Define Port Preferred, page 12-46; Show/Monitor/List Ports, page 12-102;
Preferred Services and Hosts, page 5-4.
Set/Define Port Commands
12-29