Set/Define Port Flow Control - Lantronix ETS Reference Manual

Command Reference

12.43.17 Set/Define Port Flow Control

SET
PortList
PORT
DEFINE
ALL
Sets the type of flow control on the port, and whether flow control should be enabled for the port. For
example, you can set the type of flow control to DSR/DTR, but have it disabled when you don't want flow
control.
Applies To
Errors
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Examples
See Also
CTS
DISABLED
FLOW CONTROL
ENABLED
NONE
XON
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Modem Control and DSRlogout must be disabled if CTS/RTS or DTR/DSR
flow control is selected.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
CTS
Specifies CTS/RTS (hardware) flow control.
Disabled
Deactivates the configured flow control method.
Enabled
Specifies the configured flow control method.
None
Specifies no flow control (removes a CTS, DSR, or XON setting).
XON
Specifies XON/XOFF (software) flow control.
Local> SET PORT FLOW CONTROL DSR
Show/Monitor/List Ports, page 12-102; Flow Control, page 5-2.
Set/Define Port Commands
12-39