Define Server Silentboot; Set/Define Server Slip Password - Lantronix ETS Reference Manual

Command Reference
Parameters
Examples
See Also

12.46.41 Define Server Silentboot

SET
SERVER SILENTBOOT
DEFINE
Causes the unit to attempt to boot without sending any status messages to the console port (unless there are
errors). By default, the ETS prints status messages.
This command only works with BOOT ROM versions.
Note:
Applies To
Restrictions
See Also

12.46.42 Set/Define Server SLIP Password

SET
SERVER SLIP PASSWORD
DEFINE
Configures the password required to start SLIP mode on a port. If the password is not provided on the
command line, the server will prompt the user to enter it.
Applies To
Restrictions
Parameters
limit
Enter a value between 0 and 8. The default limit is 4 sessions.
None
Returns the session limit to the default value of 8.
Local> SET SERVER SESSION LIMIT 2
Set/Define Port Session Limit, page 12-50; Show/Monitor/List Server, page
12-108; Show/Monitor Sessions, page 12-111; Enabling Server-Wide Port
Characteristics, page 4-1.
ENABLED
DISABLED
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
You must be the privileged user to use this command.
Show/Monitor/List Server, page 12-108; Editing the Boot Parameters, page 3-
7.
passwd
NONE
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
You must be the privileged user to use this command.
passwd
Enter a password of up to 6 alphanumeric characters. Entering a null string
(" ") disables the password.
Set/Define Server Commands
12-81