Lantronix ETS Reference Manual page 151

LAT Host Setup
Table 9-3: Configuring LAT on VMS Host Using a Service, cont.
Area to check
The LAT characteristic has been
enabled on the service
LAT licensing
The LAT symbiont is specified as the
queue process on the VMS host
For DCPS: there is a bidirectional path
to the printer and the printer is locked
into PostScript mode
Explanation
Use the Show Service Local Characteristics command from
a network login.
To use LAT you must obtain a LAT license from your dealer
or from Lantronix. Then use the Define Protocol LAT
License command on your ETS.
Use the VMS command Show Queue/Full queue_name to
see the queue characteristics.
Lock the printer in PostScript mode and issue the Test Ser-
vice PostScript Count n command. This command sends a
job to the printer and waits for the response.
Troubleshooting
9-9