Set/Define Port Type; Set/Define Port Username - Lantronix ETS Reference Manual

Set/Define Port Commands
See Also

12.43.41 Set/Define Port Type

SET
PortList
PORT
DEFINE
ALL
Describes the type of device connected to the port.
Applies To
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
See Also

12.43.42 Set/Define Port Username

SET
PortList
PORT
DEFINE
ALL
Specifies a username for the port. When a username is defined, users will not be asked to enter a username
when logging in to the port.
Applies To
12-54
Show/Monitor/List Ports, page 12-102; Terminal Type, page 5-13.
ANSI
TYPE
SOFTCOPY
HARDCOPY
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
ANSI
VT100-compatible devices.
Softcopy
VT100 without clear screen or cursor controls (the default).
Hardcopy
Deleted characters are echoed between backslashes; there is no cursor
movement.
Show/Monitor/List Ports, page 12-102; Other Port Characteristics, page 5-11.
username
USERNAME
NONE
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Command Reference