Set Gateway Ip Address; Netmask: Number Of Bits For Host Part; Set Dns Server Ip Address; Table 6-2. Standard Ip Network Netmasks - Lantronix XPort User Manual

For example, if the third octet is 0.0.5.0, the AutoIP and BootP options are disabled; only
DHCP is enabled. (The value 5 results from adding the binary equivalents of 0 and 2.) This is
the most common setting when using DHCP.

Set Gateway IP Address

The gateway address, or router, allows communication to other LAN segments. The gateway
address should be the IP address of the router connected to the same LAN segment as the
unit. The gateway address must be within the local network. The default is N (No), meaning
the gateway address has not been set. To set the gateway address, type Y and enter the
address.
Set Gateway IP Address (N) ? Y
Gateway IP addr ( 0) ( 0) ( 0) ( 0)_

Netmask: Number of Bits for Host Part

A netmask defines the number of bits taken from the IP address that are assigned for the
host part.
Netmask: Number of Bits for Host Part (0=default) (0) _
Note: Class A: 24 bits; Class B: 16 bits; Class C: 8 bits
The unit prompts for the number of host bits to be entered, then calculates the netmask,
which appears in standard decimal-dot notation (for example, 255.255.255.0) when the saved
parameters display.
Network Class

Set DNS Server IP Address

The DNS server allows the name of a remote machine to be resolved automatically. The
default is N (No), indicating the DNS server address has not been set. To set the DNS server
address, type Y. At the prompt, enter the DNS server address. If the device is DHCP
enabled, the DHCP server provides the DNS server IP address, which will override this
configured value.
Note: This setting is applicable only in Manual Connection mode.
Set DNS Server IP addr (N) ? _
XPort® Device Server User Guide

Table 6-2. Standard IP Network Netmasks

Host Bits
A 24
B 16
C 8
6: Setup Mode: Server Configuration
Netmask
255.0.0.0
255.255.0.0
255.255.255.0
44