Set Session Commands; Set Session Delete; Set Session Echo - Lantronix ETS Reference Manual

Command Reference
Parameters
Examples
See Also

12.48 Set Session Commands

12.48.1 Set Session Delete

SET SESSION DELETE
Allows you to change what is sent to the remote TCP/IP host when you press the Delete key. This command
has no effect in Local mode or on LAT sessions, nor does it have any effect if Passthru or Passall is in effect.
This command and the Set Session Newline command may be helpful if you are getting odd output from a
Telnet session.
Applies To
Errors
Parameters
Examples
See Also

12.48.2 Set Session Echo

SET SESSION ECHO
Requests that the ETS perform local echoing for TCP connections. The default is Disabled, on the
assumption that the remote host will provide echoing.
ServiceName
The hostname to which LAT users will connect, up to 16 characters long. An
identification string showing it is a Telnet connection to the host will be added
if not specified.
Local> SET SERVICE hydra VIRTUAL ENABLED
Clear/Purge Service, page 12-7; Show/Monitor/List Services, page 12-111;
LAT and TCP/IP Connectivity, page 2-15.
DELETE
BACKSPACE
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
An error is returned if no sessions are active.
Delete
Sends a delete character (ASCII 0x7f) when the Delete key is pressed.
Backspace
Sends a backspace character (ASCII 0x8, Ctrl-H) when the Delete key is
pressed.
Local> SET SESSION DELETE BACKSPACE
Set Session Newline, page 12-94; Set Session Passall, page 12-95; Set Session
Passthru, page 12-95.
ENABLED
DISABLED
Set Session Commands
12-93