Netmask: Number Of Bits For Host Part; Set Dns Server Ip Address; Change Telnet Configuration Password; Table 6-2. Standard Ip Network Netmasks - Lantronix UDS1100 User Manual

default setting is N (No), meaning the gateway address has not been set. To set the
gateway address, type Y and enter the address.

Netmask: Number of Bits for Host Part

A netmask defines the number of bits taken from the IP address that are assigned for
the host part.
Netmask: Number of Bits for Host Part (0=default) (0) _
Note:
Class A: 24 bits; Class B: 16 bits; Class C: 8 bits
The unit prompts for the number of host bits to be entered, then calculates the
netmask, which appears in standard decimal-dot notation (for example,
255.255.255.0) when the saved parameters display. The default setting is 0.
Network Class
A
B
C

Set DNS Server IP Address

The DNS server allows the name of a remote machine to be resolved automatically.
The default is N (No), indicating the DNS server address has not been set. To set the
DNS server address, type Y. At the prompt, enter the DNS server address. If the
device is DHCP enabled, the DHCP server provides the DNS server IP address,
which will override this configured value.
Note: This setting is applicable only in Manual Connection mode.

Change Telnet Configuration Password

Setting the Telnet configuration password prevents unauthorized access to the setup
menu through a Telnet connection to port 9999 or through web pages. The password
must have 4 characters. The default setting is N (No).
Change telnet config password (N) ? _
An enhanced password setting (for Telnet access only) of 16 characters is available
under
Security Settings (Option 6)
Note: You do not need a password to access the Setup Mode window by a
serial connection.
UDS1100 User Guide
Set Gateway IP Address (N) ? Y
Gateway IP addr (000) (000) (000) (000)_

Table 6-2. Standard IP Network Netmasks

Host Bits
24
16
8
6: Setup Mode: Server Configuration
Netmask
255.0.0.0
255.255.0.0
255.255.255.0
on page 57.
40