Set/Define Service Password; Set/Define Service Ports - Lantronix ETS Reference Manual

Command Reference

12.47.12 Set/Define Service Password

SET
SERVICE ServiceName PASSWORD
DEFINE
Specifies an access password that users must enter to connect to the service. If the password is not given on
the command line, the user will be prompted for it.
Applies To
Restrictions
Parameters
Examples
See Also

12.47.13 Set/Define Service Ports

SET
SERVICE ServiceName PORTS
DEFINE
Specifies a list of ports that will support or offer this service. If Enabled or Disabled is specified, the ports
listed will be added or removed from the port list, respectively. If neither option is given, the ports listed
will replace the old list. Ports offering a service must be in the correct access mode for connections to
succeed.
Applies To
Restrictions
Parameters
Examples
See Also
passwd
NONE
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
You must be the privileged user to use this command.
passwd
Choose a password of up to 6 alphanumeric characters.
None
Clears any previously-configured password for the given service.
Local> DEFINE SERVICE lab5 PASSWORD "this"
Clear/Purge Service, page 12-7; Show/Monitor/List Services, page 12-111.
PortList
ALL
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
You must be the privileged user to use this command.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Local> SET SERVICE lab5 PORTS 3,4,7-8 ENABLED
Clear/Purge Service, page 12-7; Define Port Access, page 12-27; Show/
Monitor/List Services, page 12-111; Creating Services on page 4-12.
Set/Define Service Commands
ENABLED
DISABLED
12-89