Ppp, Ppp Configuration Parameters; Nat Configuration Group - Multitech MultiModem rCell User Manual
Intelligent wireless router
Hide thumbs
Also See for MultiModem rCell:
- User manual (79 pages) ,
- Quick start manual (16 pages) ,
- User manual (64 pages)
Table of Contents
Advertisement
Chapter 3 – Using the Web Management Software
PPP, PPP Configuration Parameters
NAT Configuration Group
NAT:
Enable or disable NAT (Network Address Translation). The default is Enable.
Note:
For routing to take effect, enable then save the configuration.
Enabling NAT
Your LAN can use one set of IP addresses for internal traffic and a second set of addresses for external traffic. The
router with NAT does the simple IP routing between the LAN interface and the WAN interface. NAT hides the LAN
address behind a single IP address on the wireless side.
Your internal addresses are shielded from the public Internet.
MultiModem rCell User Guide
49
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiModem rCell and is the answer not in the manual?