Ethertalk; Information Checklist - Xerox WorkCentre 7232 System Administrator Manual

7 EtherTalk

This chapter explains how to set up the machine to operate on an EtherTalk network.
The following information is provided.
NOTE: This Protocol is only available when the PS Option is installed.
Information Checklist – page 95
EtherTalk Environments – page 96
EtherTalk Installation – page 96
Installation Procedure – page 96
Network Communication Setup – page 96
Workstation Setup – page 97
Test Print – page 97

Information Checklist

Before installing EtherTalk on the machine, make sure that the following items are
available or have been performed.
An existing operational EtherTalk network with Macintosh workstations
equipped with Ethernet network interface cards is required. These
procedures are not designed to install an EtherTalk network.
Macintosh System versions 7.5 or later, 8.x, 9.x, or Mac OS X 10.x
Test the machine to make sure that it is installed fully and functioning
correctly.
Install the Adobe PS print driver, or PPD (optional).
If problems are encountered during the machine installation, refer to the Problem
Solving chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
Xerox WorkCentre 7232/7242 System Administration Guide
Item By
Customer
Customer
Customer
Customer
95