Microsoft Networking; Information Checklist - Xerox WorkCentre 7232 System Administrator Manual

8 Microsoft Networking

This chapter explains how to set up the machine to operate on a Microsoft network. The
following information is provided.
Information Checklist - page 99
SMB Environments - page 100
SMB Installation - page 101
Installation Procedure - page 101
Network Communication Setup - page 101
Workstation Setup - page 103
Test Print - page 103

Information Checklist

Before starting the Microsoft networking installation procedures, make sure that the
following items are available or have been performed.
An existing operational Microsoft network is required. These procedures
are not designed to install a Microsoft network.
Obtain and record the following information, if required:
• IP address
• Gateway address
• Subnet mask (for IPv4) / Prefix (for IPv6)
• Host name
Refer to the Glossary for additional information about the Gateway
Address and Subnet mask, if needed.
Test the machine to make sure that it is installed fully and functioning
correctly.
Install the print driver.
If problems are encountered during the installation, refer to the Problem Solving
chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
Xerox WorkCentre 7232/7242 System Administration Guide
Item By
Customer
Customer
Customer
Customer
99