Table of Contents
Advertisement
5 EtherTalk
This chapter explains how to set up the machine to operate on an EtherTalk network.
The following information is provided.
Information Checklist – page 67
EtherTalk Environments – page 68
EtherTalk Installation – page 68
Installation Procedure – page 68
Network Communication Setup – page 68
Workstation Setup – page 70
Test Print – page 70
Information Checklist
Before installing EtherTalk on the machine, make sure that the following items are
available or have been performed.
An existing operational EtherTalk network with Macintosh workstations
equipped with Ethernet network interface cards is required. These
procedures are not designed to install an EtherTalk network.
Macintosh System versions 7.5 or later, 8.x, 9.x, or Mac OS X 10.2
Obtain and record the following information:
• IP address
• Gateway address
• Subnet mask
• Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed.
Test the machine to make sure that it is installed fully and functioning
correctly.
Install the Adobe PS print driver, or PPD (optional).
If problems are encountered during the machine installation, refer to Problem Solving
chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide
Item
By
Customer
Customer
Customer
Customer
Customer
67
Advertisement
Table of Contents
