▼
To enable automatic feed
Press the Extra key.
1
Select 'Scanner' with the
2
Press the
3
Select 'Autofeed orig.' with the
4
Press the
5
Select 'on' or 'off' with the
6
Press the 'confirm' key.
7
Define settings for the next original
For each original you need to copy you can specify new settings.
▼
Define settings for the next copy job
Select all the needed settings for the next original.
1
Insert the next original.
2
Copy on pre-cut sheets
If you copy a job on a media type and/or size that is not available on one of the
paper rolls, you can manually feed sheets instead of reloading paper rolls. You
can insert pre-cut copy material in this slot, one sheet at a time. To set the time
out for manual feed refer to 'Set the time-out for manual feed' on page 53.
▼
Copy on pre-cut sheets
Enter the type of the copy material on the printer operator panel.
1
Press the 'media' key on the scanner panel to select 'manual feed'. The
2
indicator lights up.
The minimum length of the print material must be 420 mm.
Note:
Use the Océ TDS320 to copy
or
key, to enter the 'Scanner' menu.
key, to enter the 'Autofeed orig.' menu.
or
key.
or
key.
key.
51