Define Settings For The Next Original; Account Logging - Oce TDS600 User Manual

Define settings for the next original

You can define the settings for each original you want to copy. When
'Automatic feed' is enabled, you should bear in mind that the original is
automatically pulled into the scanner. If you want to be absolutely sure about
the settings that belong to an original, insert an original when the settings are
correct.
To increase your versatility at the scanner input side, you can ask your
Note:
key operator to switch off Automatic feed. When using the scanner with
automatic feed off, you must press the start button for each new original to be
scanned. This offers you the possibility to change the settings for the next
original, even if you already put the original in place on the scanner feed table.
Define settings for the next copy job
Select all settings required for the next original.
1
Insert the next original.
2
If 'Automatic feed' is off, press the start button.
If 'Automatic feed' is on, the original is fed automatically.
You can enable or disable this function from the 'Scanner' card in the
Note:
'Original' section. See figure 15 on page 47.

Account logging

For accounting purposes, the system is able to log job information for each job.
The job identification attributes and the number of print jobs are logged in the
account file. For more information on account logging (see 'Océ Power Logic:
Account logging' on page 225)
The account settings are only available if the accounting option is
Note:
enabled in the system configuration.
Use the Océ TDS600 to copy 53