Crankshaft Runout - Suzuki Katana 1100 Service Manual

3-39 ENGINE
• If the right-side thrust bearing is within the standard range,
reinsert the right-side thrust bearing, and remove the left-side
thrust bearing.
• As shown in the illustration, use a thickness gauge to
measure the clearance before inserting of the left-side thrust
bearing, and select a left-side thrust bearing from the
selection table.
Thrust bearing selection table
Clearance before Color T h r u s t !
I,
Thrust clearance
inserting left-side
I
~
(Part No.) bearing I { ­
thrust bearing thickness
---------- --- -------HOql;
2.42 - 2.44 mm Black 2.36 - 2.38 mm
~~~~~~~_~)96~_~~__
(12228-48BOO-OHO) (0.0929 - 0.0937 in)
2.44 - 2.46 mm Orange 2.38 - 2.40
~
_(00961_-_0.09_69iI1L_i'. __
(1_22~8-48BOO-0~
(0.0937 -
0.094~~
2.46 - 2.48 mm Blue
I
2.40 - 2.42 mm
1
(00969 - 00976 in) (12228-48BOO-OFO)
I
(0.0945 - 0.0953 in)
- - -2.4 8-=-2~5-6--m-m- --i--'--G-r-ee-n
2.4 2 - 2.4 4 m m
0.04 - 0.08 mm
(0.002 - 0.003 in)
_JO.~0._.98~=--~
. . 0992
~.
_ _ (.12228-48BOO-000)
252 - 254 mm
r-
Red
(0.0961
2.46
- 0.0969 in)
- 2.48 mm
f--J0099~
- 0.1_000 inL_+-- (12228-48BOO-OCO) (0.0969 - 0.0976 in)
2.54 - 256 mm
+'
Brown 2.48 - 2.50 mm
___ ( 0_. ~o.0~_=-..c>.:~_OO~_in_) _ _ ( 13~~~~_8_BO_0_-0_B_0_)
- --+-
(0.0976- 0.0984 in)
2.56 - 257 mm Pink
' I
2.50 - 2.52 mm 0.04 - 007 mm
(0.1008 - 01012 in) ! (12228-48BOO-OAO)
1
(0.0984 - 0.0992 in) (0.002 - 0003 in)
-Color cord
• After selecting a left-side thrust bearing, insert it and again
perform the thrust clearance measurement to make sure it
falls wihin the standard range.
NOTE
Right-side thrust bearing has the same specification as the
Yellow of left-side thrust bearing.
J
CRANKSHAFT RUNOUT
Support the crankshaft with "V" blocks as shown, with the two
,
end journals resting on the blocks. Set up the dial gauge, as
shown, and rotate the crankshaft slowly to read the runout.
Replace the crankshaft if the runout is greater than the limit.
Crankshaft runout specification
Service Limit: 0.05 mm (0.002 in)
l