Suzuki Katana 1100 Service Manual page 84

ENGINE 3-54
• Coat SUZUKI Bond No. 1207B lightly to the portion around
mating surface between upper and lower crankcases as
shown in the Fig.
99104-31140: SUZUKI Bond No. 1207B
• Install the dowel pins, a new gasket and clutch cover, and
tighten the cover bolts securely.
NOTE:
Fit up the two gaskets to the clutch cover bolts
®
correctly as
shown in the Fig.
CAUTION:
Use only new gasket to prevent oil leakage.
NOTE:
When replacing the oil pressure switch, apply SUZUKI Bond
No. 1207B to its thread lightly.
99104-31140: SUZUKI Bond No. 1207B
• Install the signal generator stator with three screws.
• Connect the oil pressure switch lead wire to the oil pressure
switch terminal.
• Make sure to fit the slot
CD
on the back surface of the signal
generator rotor over the locating pin
®
at the end of
crankshaft.
NOTE:
Bond No. 1207B should be applied to the groove of the signal
generator lead wire grommet @.
99104-31140: SUZUKI Bond No. 1207B
• Hold the crankshaft turning nut and tighten the rotor bolt
with specified torque using 6-mm hexagon wrench.
09914-25811: 6 mm "T" type hexagon wrench
Tightening torque: 25 - 35 N·m
(2.5 - 3.5 kg-m. 18.0 - 25.5 Ib-ft)