Suzuki Katana 1100 Service Manual page 85

3-55 ENGINE
• Pass the signal generator lead wire through upper crankcase
as shown in the Fig.
• Install the oil seal retainer with four bolts and positively bend
the lock portion of the retainer.
• Insert the clutch push rod into the countershaft.
• Install the neutral position indicator switch with two screws.
NOTE:
When installing the neutral position indicator switch, be sure
to locate the spring, switch contact and O-ring.
• Degrease the tapered portion of the starter clutch and also
the crankshaft. Use nonflammable cleanig solvent to wipe
off the oily or greasy matter to make these surfaces com ­
pletely dry.
NOTE:
Apply a small quantity of THREAD LOCK SUPER" 1303" to the
starter clutch mounting bolt.
99000-32030: Thread lock super "1303"
• Tighten the starter clutch mounting bolt to the specified
torque by using the special tool and torque wrench.
Tightening torque: 143 - 157 N·m
(14.3 - 15.7 kg-m, 103.5 - 113.5 Ib-tt)
09920-34810: Starter clutch holder