Suzuki Katana 1100 Service Manual page 47

3-17 ENGINE
• Remove the shim
CD
and O-ring
0·
• Remove the oil sump filter
CD
by removing the three bolts.
• Remove the left oil pipe
0
by removing the bolt.
• Remove the oil sump filter guide
®
by removing the two
bolts.
• Remove the lower crankcase securing bolts and nut.
• When removing the crankshaft tightening bolts, loosen
them in the descending order of numbers assigned to these
bolts.
NOTE:
"*
Two allen bolts are used for tightening crankshaft at the
portion
0.
"*
Before removing the crankshaft tightening bolts, remove
the main oil gallery plug @.
"*
When installing the main oil gallery plug
@,
replace the
O-ring with new one and tighten it to the specified torque.
09914-25811: 6 mm 'T' type hexagon wrench
09900-00401: "L" type hexagon wrench set
Tightening torque
Main oil gallery plug @: 35 - 45 N·m
(3.5 - 4.5 kg-m, 25.5 - 32.5 Ib-ft)
• Make sure that all bolts are removed without fail. Hammer
lightly the lower crankcase side with a plastic hammer to
separate the upper and lower crankcase halves and then lift
the latter.
CAUTIOI\J:
Do not drop the crankshaft journal bearings from the lower
crankcase.