Starter Motor Reassembly; Armature Coil; Oil Seal; O-Ring - Suzuki Katana 1100 Service Manual

6-13 ELECTRICAL SYSTEM
ARMATURE COIL
Using a pocket tester, check the coil for open and ground by
placing probe pins on each commutator segment and rotor
core (to test for ground) and on any two segments at various
places (to test for open), with the brushes lifted off the
commutator surface.
If the coil is found to be open-circuited or grounded replace
the armature. Continuous use of a defective armature will
cause the starter motor to suddenly fail.
09900-25002: Pocket tester
OIL SEAL
Check the seal lip for damage or oil leakage. If any damage is
found, replace it.
---~
STARTER MOTOR REASSEMBLY
a-RING
CAUTION:
Replace the a-rings with new ones to prevent oil leakage
and moisture.
BRUSH HOLDER
• Align the groove of brush holder with the lug on the starter
motor case.
HOUSING END (Brush-side)
• Apply a small quantity of moly paste to the armature end.
99000-25140: SUZU KI Moly paste