Ignition Coil Inspection (With Electro Tester); Ignition Coil Inspection (With Pocket Tester); Signal Generator Inspection (With Pocket Tester) - Suzuki Katana 1100 Service Manual

6-9
ELECTRICAL
SYSTEM
INSPECTION
IGNITION COIL (Checking with Electro Tester)
NOTE:
Make sure that the three-needle sparking distance of electro
tester is set at 8 mm (0.3 in).
• With the tester and jumper wire, test the ignition coil for
sparking performance in accordance with the following two
steps.
STEP
(1) :
Connect the jumper wire to the spark plug cap and
ignition coil ground.
STEP @ : Switch over the jumper wire to the other plug cap
and ground.
If no sparking or orange color sparking occures in the above
conditions, it may be caused by defective coil.
09900-28106:
Elelctro tester
STD Spark performance: 8 mm (0.3 in)
IGNITION COIL (Checking with Pocket Tester)
• A SUZUKI pocket tester or an ohm meter may be used,
instead of the electro tester. In either case, the ignition coli
is to be checked for continuity in both primary and secondary
windings. Exact ohmic readings are not necessary, but, if the
windings are in sound condition, their continuity will be
noted with these approximate ohmic values.
09900-25002: Pocket tester
Ignition coil resistance
Primary tap - 'tap 3 - 5
n
Tester range: (. 1 Uj
Secondary: Plug cap - Plug cap 25 - 45 kU
Tester ran~Je: (. 1 kll)
SIGNAL GENERA TOR
(Checking with Pocket Tester;
• Remove th," se«! and left frrlt"ne c;over.
• MeClSllre ttlP
r...,s;stanc:e
bPhN8PfJ
lead wires. If the resistance
:~: !nfmity or less thar: the specifications, the signal generator
nlust t')e r
~?place(j,
09900·25002: Pocket tester
STD resistance
Blue .... Yellow: 135 -·200
!!
T ester range: (. 100m
,----------------- . _ - - - - -
- - - ---
Electro tester
Jumper wire
r-------------,
r
-EJ :
~
: ­
.. I
I
<p
I I
! : :
~
I :
- L
J
. )
J!j . :