Suzuki Katana 1100 Service Manual page 94

ENGINE 3-64
• Coat SUZUKI Bond No. 1207B lightly to the portion around
mating surface between upper and lower crankcases as
shown in the Fig.
99104-31140: SUZUKI Bond No. 1207B
~_11!.4""4
...
4't~$
-.=::!ii
,
.
.
~
t
• Install a new gasket and the signal generator cover with five
bolts.
NOTE:
Fit up the gasket to the signal generator cover bolt
®
correctly
as shown in the Fig.
CAUTION:
Use a new gasket to prevent oil leakage.
• Before installing the cylinder head cover gaskets on the
cylinder head cover, apply SUZUKI Bond No. 1207B to the
grooves of the head cover.
• Apply SUZUKI Bond No. 1207B to the four cam end caps
of the gasket and shown in the Fig.
99104-31140: SUZUKI Bond No. 1207B
• Place the cylinder head cover on the cylinder head.
• Fit up the four gaskets to each head cover union bolt.
• Seat the eight gaskets to each exact position.
CAUTION:
Replace the gaskets with new ones to prevent oil leakage.
• After tightening the head cover union bolts
CD
to the
specified torque, tighten the head cover bolts
0
to the
specified torque.
Tightening torque
Head cover union bolt
CD:
13 - 15 N·m
(1.3 - 1.5 kg-m. 9.5 - 11.0 Ib-ft)
Head cover
0:
13 - 15 N·m
(1.3 - 1.5 kg-m. 9.5 - 11.0 Ib-ft)
2
'\~
. . ~.'",~~..J,
. _~. -'-'-" cz'C:{";"'"
, -2""'-'