Starter Motor Reassembly And Installation - Suzuki DR-Z70 Service Manual

ARMATURE COIL
Check for continuity between each segment and the armature
shaft using the multi-circuit tester.
If there is no continuity between the segments or there is conti-
nuity between the segments and shaft, replace the armature
with a new one.
09900-25008: Multi-circuit tester set
Tester knob indication: Continuity test (
OIL SEAL
Check the oil seal lip for damage or leakage.
If any defects are found, replace the housing end assembly.
BUSH
Check the bush for wear and damage.
If any defects are found, replace the starter motor case.
STARTER MOTOR REASSEMBLY AND
INSTALLATION
Reassemble and installation the starter motor in the reverse
order of disassembly. Pay attention to the following points:
• Apply SUZUKI SUPER GREASE "A" to the lip of the oil seal
and bearing.
99000-25010: SUZUKI SUPER GREASE "A"
• Apply a small quantity of SUZUKI MOLY PASTE to the arma-
ture shaft.
99000-25140: SUZUKI MOLY PASTE or equivalent
)
or equivalent
ELECTRICAL SYSTEM 6-13