Mitsubishi Electric MELSEC Q Series User Manual page 234

íç1
(From previous page)
Set parameters for non-multiple CPU system.
Write set parameters in the hard disk/floppy disk.
Figure 8.4 Parameter setting procedure for new multiple CPU system creation
íç1
Basic
Note8.5
Since the number of mountable CPU modules is three when using a Basic model QCPU, "PLC No.4" is not selectable.
Basic
Note8.6
For the Basic model QCPU or the Process CPU, using the AnS/A series compatible I/O modules and special function
modules is not allowed.
Completed
Process
CHAPTER8 STARTING UP THE MULTIPLE CPU SYSTEM
Control PLC (mandatory item)
Select control PLC (PLC No. 1 to PLC No. 4)
Note8.5
for each slot.
For the intelligent function module of function
version A, set Control PLC to PLC No. 1.
For the AnS/A series-compatible module, set
Control PLC to all same High Performance
Note8.6
model QCPU.
1
2
3
4
5
6
7
8
8 - 9