Mitsubishi Electric MELSEC Q Series User Manual page 216

PLC parameter
No. of PLC
Host CPU number
Operation mode
Multiple CPU synchronized boot-up
Online module change
All CPUs can read all inputs
All CPUs can read all outputs
Multiple CPU high speed transmission area setting
Multiple CPU high speed transmission
Multiple CPU
function
settings
CPU specific send range
Auto refresh
Number of points
Start
Advanced settings
Restricted system area
Communication area setting (Refresh setting)
Send range for each PLC
PLC side device
*
1:Necessity of setup column
: Items that must be set up for multiple CPU system (operations not possible if not set up.)
: Items that may be set up when required for multiple CPU system
---- : Items that are the same as single CPU system.
*
2:Necessity of same setting column
: Items that must be the same settings for all CPU modules on the multiple CPU system.
: Items that must be the same settings for all QCPUs and PC CPU module on the multiple
CPU system
(items that do not have settings for Motion CPUs).
---- : Items that can be setup up individually for each CPU modules on the multiple CPU system.
CHAPTER6 PARAMETER ADDED FOR MULTIPLE CPU SYSTEM
Necessity
of setup
*3
Necessity
of same
Reference
*1
*2
setting
Section 6.1.1
Section 6.1.2
Section 6.1.7
Section 6.1.3
Section 6.1.4
Section 6.1.8
----
----
Section 6.1.5
----
1
2
3
4
5
6
7
8
6 - 4