Figure 9 Turning On The Library; Figure 10 Setup Wizard - Initial Screen - Quantum Scalar i40 User Manual

Chapter 2: Initial Installation and Setup
Turning the Library ON and Configuring Network Settings

Figure 9 Turning on the Library

Figure 10 Setup Wizard –
Initial Screen
20
2 When initialization completes, the Setup Wizard screen appears on
the operator panel (see
contains a menu bar with operations that correspond to the four
physical buttons below it. The menu operations and button
functions change with each screen.
3 Before proceeding, verify the Ethernet cable is connected and all of
your tape drives are installed.
4 Do one of the following:
• To configure basic network settings using the Setup Wizard,
press the button below Next on the menu bar. You will be
guided through a series of screens where you can accept or
change the default configuration settings (date, time, IP
address, licenses, partitions, I/E station slots, and cleaning slots).
Once you accept a setting, you move to the next one.
Power
button
Figure 10). The operator panel screen
Quantum Scalar i40 and Scalar i80 User's Guide
Power LED
Menu bar
Navigation/selection
buttons