Figure 14 Setup Wizard - Licenses Screen - Quantum Scalar i40 User Manual

Figure 14 Setup Wizard –
Licenses Screen
Quantum Scalar i40 and Scalar i80 User's Guide
Turning the Library ON and Configuring Network Settings
• If you choose IPv6 as the protocol, the library supplies a
stateless IPv6 address and displays it, along with other
network settings, on two screens. Use the Next and Back
buttons to view the screens. You can only change these
settings via the Web client.
7 The Current Licenses screen appears, which lists the number of
licensed and unlicensed slots in the library and whether an
Advanced Reporting license is installed (see
ordered Capacity on Demand (COD) or Advanced Reporting
features, they may already be installed on your library, depending
on the library configuration you ordered. If they are not installed,
you will have received, separately, a License Key Certificate
containing instructions on how to retrieve your license key from the
Quantum Web site. Once you have retrieved your license key, you
may add it now or any time later. (If you did not receive your License
Key Certificate, contact Quantum Support.)
Do one of the following:
• To accept the settings and go to the next step, press Accept.
• To change the settings, press Change. You can only change the
settings if you have a new license key to enter. If you have a
license key, press Add, then enter the license key using the
directional buttons as described in
Accept when complete. If you need to add another license key,
perform the Change operation again.
8 The Current Configuration screen appears, displaying the default
number of partitions, I/E station slots, and cleaning slots (see
Figure 15).
Chapter 2: Initial Installation and Setup
Figure 14). If you
Step 5 on page 21 and press
23