Setup Wizard - Quantum Scalar 50 Quick Start Manual

Setup Wizard

3 For the network information such as the IP address to be active or take effect, you
must power down the library by holding down the power button located on the front
of the library after changing any of the network settings (see
The library shuts down.
4 Push the power button to start the library.
The Scalar 50 tape library is initially configured. To complete the installation, continue
with Setup Wizard.
The leads you through the process of setting up the most common options
Setup Wizard
for this library to be operational. Detailed customization options, including settings
modified by this wizard, can be changed via the menus under the
The library will need to reboot for changes to take effect. Host application
Note:
software may need to be restarted/rebooted as well.
1 On the host computer, open the internet browser software.
2 In the field, type http://IPaddress/ where IP address is the IP address for the
Address
Quantum Scalar 50.
3 Enter the username and password and click
Note: The default username and password is
The page displays (see
Overview
.
OK
figure 39):
Setup Wizard
Scalar 50 Tape Library
figure 22).
tab.
Setup
.
admin
31