Specifying settings using PageScope Web Connection
11.13 Report Output Settings (Administrator mode)
The output conditions of the send result reports and communication control
reports can be specified.
The following settings can be specified.
Item
TX Report
(Single
destination)
TX Report
(Multiple
destination)
Activity Report
!
Detail
If "Activity Report" is set to "Output On", the activity report contents can
be outputted as a CSV file and sent by e-mail to the administrator when
the activity report is printed. To manage the contents of the activity report
as data, specify the e-mail address of the administrator.
For details on specifying the e-mail address of the administrator, refer to
"System (Administrator mode)" on page 11-23.
To specify the report output settings
1
In the Administrator mode, click the [Fax/Scan] tab.
–
For the procedure to log on to Administrator mode, refer to "Log-
ging on to Administrator mode" on page 11-9.
2
Click [Report Settings].
3
Specify each item, and then click [Apply].
362/350/282/250/222
Description
Select the output of the result report sent to a single destination.
Output On: Outputs regardless of the results.
If TX Fail: Outputs only when undeliverable.
Output Off: Does not output regardless of the results.
Select the output of the result report sent to multiple destinations.
Output On: Outputs regardless of the results.
If TX Fail: Outputs only when undeliverable.
Output Off: Does not output regardless of the results.
Select the communication control report that is output every 50
transmissions.
11
11-45