Konica Minolta bizhub 362 User Manual page 274

Utility mode
Bit
4, 3, 2
1
0
*Example 1: If bits 7, 6, 5, 4, 3, 2 and 1 are set to "0", "0", "0", "1", "0", "1"
and "0" (maximum discard length=0mm, maximum reduction ratio=65%,
trailing edge operation=reduce) and the paper is 70% of the received image,
the image is reduced 70% without discarding the trailing edge and printed to
fit within a single page.
*Example 2: If bits 7, 6, 5, 4, 3, 2 and 1 are set to "0", "0", "0", –, –, – and "1"
(maximum discard length=0mm, trailing edge operation=discard) and the re-
ceived image is longer than the paper, the image is printed on two pages
without reducing it or discarding the trailing edge.
362/350/282/250/222
Description
An excess longer than the
length specified by bits 5, 6
and 7 is reduced to fit within
the paper. Specify the maxi-
mum of this reduction ratio.
(Available only if bit 1 is set to
"0" while printing received
documents.)
For example, if "90%" is set,
the document is reduced with-
in the range of 90% to 100%.
• The excess is printed on a
separate page if it does not
fit within the printable area
of the page with the maxi-
mum reduction ratio speci-
fied here.
Specifies whether the docu-
ment is reduced or the excess
is discarded when the re-
ceived document is longer
than the printable area of the
paper. (Available only when
printing received documents.)
• Bits 7, 6 and 5 and bits 4, 3
and 2 can be specified for
this setting.
----------------------------------
Setting Description
000 100%
001 95%
010 90%
011 85%
100 80%
101 65%
110 60%
111 *Do not specify
this setting for
this function.
0 Reduces
1 Discards
1 *Do not change
this bit when
specifying set-
tings for this
function.
10
Page Refer-
ence
p. 5-3
p. 5-3
----------
10-79