Source Selection Controls - SMART Board X800ix User Manual

A P P E N D I X A
Remotely managing your interactive whiteboard system
The following table describes the powerstate commands:
Command
on
off
off now
get powerstate
The following table describes the powerstate fields:
Field
Powering
On
Cooling
Confirm off
Idle

Source selection controls

These commands switch input sources. The source type determines which commands can be
accepted.
Command
get input
set input [field]
The following table describes the source selection commands:
Command
get input
set input [field]
66
Description
Turns on the projector.
Starts the shutdown process. A dialog box appears with the
message, "Press Power Button to Turn off Projector." You must send
a second Off command within 10 seconds to completely turn off the
projector.
Shuts down the projector immediately. You can't delay or cancel this
command.
Indicates the projector's current powerstate.
Description
The projector is turning on.
The projector is on.
The projector is cooling.
Confirm off is a non-selectable powerstate that is returned during
stage one of the two-button off sequence.
The projector is off but still receiving power (Standby mode).
Response
input=[field]
input=[field]
Description
Returns the projector's current input.
Returns the input to one of the selectable fields.
Available when powered
off
Yes
No