C H A P T E R 6
Troubleshooting your interactive whiteboard system
Projector lights and status
The two indicator lights (Power and Service) are located on the bottom of the SMART UX60 projector.
Specific light sequences convey information about the state of the projector, including errors.
I
I M P O R T A N T
After you resolve the projector's issue, disconnect and then connect the projector power cable to
clear the indicator light sequence, and then reset the projector's status (see Resetting the projector
on page 52).
Power light
Service light
Solid amber
Off
Flashing green
Off
Solid green
Off
Flashing amber
Off
Off
Flashing red
Off
Solid red
41
Message
The projector is off but still receiving power (Standby
mode). Press the Power
The projector is in the powering (startup) power state. Wait
for the projector to finish turning on.
The projector is in the operating (on) power state. Press the
Power
button on the ECP twice to turn it off.
The projector is in the cooling power state. Wait for the
projector to finish cooling.
The projector is overheating. It could shut down
automatically.
See The "Projector Overheated" message appears on page
43 to troubleshoot the projector.
The projector has a fan issue. It could shut down
automatically.
See The "Fan Failure" message appears on page 43 to
troubleshoot the projector.
button on the ECP to turn it on.