Video Source Specification Values; Powerstate Controls - SMART Board X800ix User Manual

A P P E N D I X A
Remotely managing your interactive whiteboard system
See the following example for adjusting projector brightness:
>get brightness
brightness=55
>set brightness=65
brightness=65
>set brightness+5
brightness=70
>set brightness-15
brightness=55

Video source specification values

You can use the source input field described in Source selection controls on next page in a command
to set an absolute value or adjustment value to a source other than the active source. You can do this
while the selected source is inactive, but the source device must be connected if it isn't connected, or
you receive an invalid command response.
See the following examples, where both an HDMI connector and a VGA1 input are connected:
>set input hdmi
input=hdmi
>set brightness vga1=65
brightness vga1=65
>set brightness vga1-7
brightness vga1=58

Powerstate controls

These commands turn on or turn off the projector and request the projector's current powerstate. The
projector's powerstate determines whether certain commands are available at that time. These
settings are available, even when the projector is off.
Command
on
off
off now
get powerstate
65
Response
powerstate=[field]
powerstate=[field]
powerstate=[field]
powerstate=[field]