Connecting Your Room Control System To The Ecp; Serial Interface Settings - SMART Board X800ix User Manual

A P P E N D I X A
Remotely managing your interactive whiteboard system

Connecting your room control system to the ECP

By connecting a computer or room control system to the 4-pin connector on the ECP, you can select
video inputs, start up or shut down your interactive whiteboard system and request information such
as projector lamp use, current settings and network addresses.

Serial interface settings

The serial interface of the SMART UX60 projector acts as a Data Communications Equipment
(DCE) device and its settings can't be configured. You must configure your computer's serial
communication program (such as Microsoft® HyperTerminal) or your room control system's serial
communication settings with the following values:
Setting
Data Rate
Data Bits
Parity
Stop Bits
Flow Control
62
Value
19.2 kbps
8
None
1
None