Powerstate Controls; Source Selection Controls - SMART Board Board 600i5 Configuration And User's Manual

A P P E N D I X A
Remotely managing your interactive whiteboard system

Powerstate controls

These commands place the projector in and out of Standby mode and request the projector's current
powerstate. The projector's powerstate determines whether certain commands are available at that
time. These settings are available even when the projector is in Standby mode.
Command
on
off
off now
get powerstate
The following table describes the powerstate commands:
Command
on
off
off now
get powerstate
The following table describes the powerstate fields:
Field
Powering
On
Cooling
Confirm off
Idle

Source selection controls

These commands switch input sources. The source type determines which commands can be
accepted.
Command
get input
set input [field]
67
Response
powerstate=[field]
powerstate=[field]
powerstate=[field]
powerstate=[field]
Description
Turns on the projector.
Starts the shutdown process. A dialog box appears with the
message, "Press Power Button to Turn off Projector." You must send
a second Off command within 10 seconds to put the projector into
Standby mode.
Shuts down the projector immediately. You can't delay or cancel this
command.
Indicates the projector's current powerstate.
Description
The projector is turning on.
The projector is on.
The projector is cooling.
Confirm off is a non-selectable powerstate that is returned during
stage one of the two-button off sequence.
The projector is off but still receiving power (Standby mode).
Response
input=[field]
input=[field]
Available when in Standby
mode
Yes
No