SMART Board X800ix User Manual page 27

C H A P T E R 3
Using your interactive whiteboard system
Setting Use
Set to Default? Resets projector settings to their
default values.
Network menu
Network and VGA Activates the VGA out and network
Out features.
Status Displays the current network status
(Connected, Disconnected or Off).
DHCP Displays the status of the network's
Dynamic Host Control Protocol
(DHCP) as On or Off.
Password E-mails the network password to the e-
Reminder mail recipient.
IP Address Displays the projector's IP address in
values between 0.0.0.0 and
255.255.255.255.
Subnet Mask Displays the projector's subnet work
mask number in values between
0.0.0.0 and 255.255.255.255.
Gateway Displays the projector's default
network gateway in values between
0.0.0.0 and 255.255.255.255.
DNS Displays the projector's primary
domain name number in values
between 0.0.0.0 and 255.255.255.255.
MAC Address Displays the projector's MAC address
in xx-xx-xx-xx-xx-xx format.
Group Name Displays the projector's workgroup
name as set by an administrator
(maximum 12 characters).
Projector Name Displays the projector's name as set
by an administrator (maximum 12
characters).
Location Displays the projector's location as set
by an administrator (maximum 16
characters).
17
Notes
If you select Yes, all projector settings
reset to their defaults, reversing any
menu changes you made. This action
is irreversible.
Don't adjust this setting unless you
want to reset all of the applied settings,
or unless you're advised to by a
certified SMART Support specialist
(smarttech.com/contactsupport).
On automatically assigns the DHCP
server's IP address to the projector.
Off enables an administrator to assign
an IP address manually.
See Web page management on page
56 to set up a destination e-mail
address.