SMART Board X800ix User Manual page 4

I M P O R T A N T I N F O R M A T I O N
When mounting the projector boom on a framed or hollow wall, attach both the mounting
l
bracket and the safety tether to a stud to safely support the projector's weight. If you use only
drywall anchors, the drywall can fail, resulting in product damage and possible personal
injury.
If you remove the bolt supporting the limit strap, the projector's boom will be free to swing.
l
Make sure that the bolt is tightened, and never remove it from the unit without first supporting
the projector boom.
Do not leave cables on the floor where they can be a tripping hazard. If you must run a cable
l
over the floor, lay it in a flat, straight line and secure it to the floor with tape or a cable
management strip of a contrasting color. Handle cables carefully and avoid excessive
bending.
Do not climb (or allow children to climb) on a wall- or stand-mounted SMART Board
l
interactive whiteboard.
Do not climb on, hang from or suspend objects from the projector boom.
Climbing on the interactive whiteboard or projector boom could result in personal
injury or product damage.
There are no user-serviceable parts inside the pen tray. Only qualified personnel should
l
disassemble the pen tray's printed circuit boards, and this procedure must be done with
proper electrostatic discharge (ESD) protection.
C
C A U T I O N
Do not operate this unit immediately after moving it from a cold location to a warm location.
l
When the unit is exposed to such a change in temperature, moisture can condense on the
lens and crucial internal parts. Allow the system to stabilize to room temperature before
operation to prevent possible damage to the unit.
Do not place the unit in hot locations, such as near heating equipment. Doing so could cause
l
a malfunction and shorten the life of the projector.
Avoid setting up and using the SMART product in an area with excessive levels of dust,
l
humidity and smoke.
Do not place your SMART product in direct sunlight or near any appliance that generates a
l
strong magnetic field.
ii