Before Using For The First Time; General Procedures - George Foreman GR70CAN Owner's Manual

Before Using for the First Time

LID AND LID HANDLE ASSEMBLY
1. Locate the Lid Screw and
rubber washer from inside
the packing.
2. Position the Handle on the
outside of the Lid, at its top-
most point. Fit screw and
rubber washer through the
hole on top of the Lid. Then
screw the Lid Handle to the
top of the Lid. Hand tighten
until the Handle is secure.
(See sketch .) The Handle
must always be on the exterior of the Lid during cooking.
3. Periodically check to make sure the Handle is securely
fastened onto the Lid. Always tighten by hand; do not
over tighten.

GENERAL PROCEDURES

• Make sure the appliance is unplugged. Remove the
Temperature Control Probe and Party Time Grill!
ting both aside.
• ALWAYS make sure the Grease Tray is empty before
removing the Pan from the Base.
• To detach the Pan, from the Housing Base, gently push the
Pan Release towards the Pan to release. Then carefully lift
the Pan from the Base, at the Grease Tray end, pulling it up
and towards you.
• Completely wipe the Party Time Grill!
cloth to remove all dust. Apply a thin coating of cooking oil
and wipe out any excess with a paper towel for easy main-
tenance for next use.
• Wash Housing Base, Lid, Fusion Cup, Grill Tongs, Grease
Tray, and Skewers with warm, sudsy water and rinse. Dry
thoroughly before attaching the Party Time Grill!
inserting the Temperature Control Probe.
™ Pan with a damp
8
™ Pan, set-
™ Pan and