Hardware Installation
There are more ports on the rear, see figure 12.
Figure 12: Rear ports (right)
1 LAN port
(currently not usable, reserved for
future extensions)
Ê Connect the data cables to the server and peripherals.
I
Keyboard and mouse are to be connected via USB. There are no PS/2
ports available for these devices.
4.5
Connecting the Server to the Mains Voltage
The server has two hot-plug power supply units. This ensures a redundant
power supply. If a defect occurs in one power supply unit, the respective other
power supply unit ensures unimpaired further operation. Each hot-plug power
supply may be replaced while the system is operating (see "Replacing a Hot-
plug Power Supply Unit" on page 71).
V
CAUTION!
The server automatically sets itself to a voltage in the range of
200 V - 240 V. Make sure that your local voltage is within this range.
A3C40069794
Connecting the Server to the Mains Voltage
2 SCSI port (optional, connected to
SCSI channel B or to an
additional PCI board)
2
1
41