Table of Contents
Advertisement
Hardware Installation
4.6
Connecting the Server to the Line Voltage
In its basic configuration level the server has a hot-swap power supply unit. A
second hot-swap e power supply unit can be added to achieve redundant power
supply. If a defect occurs in one power supply unit, the respective other power
supply unit ensures unimpaired further operation.
V
CAUTION!
The server automatically sets itself to a voltage in the range of 100 V to
240 V. Make sure that your local voltage is within this range.
Figure 21: Connecting the server to the line voltage
Ê Connect the insulated connector of the power cable to the power supply unit
of the server (1), and the power plug to a grounded mains outlet (2) of the
in-house mains and/or into the mains socket strip of the rack (see Technical
Manual of the rack).
I
A phase redundancy in the power supply of the server can be set up if
two hot-swap power supply units are installed.
In this case the two power supply units are directly connected either to
two different phases or to two different power circuits of the in-house
mains.
A26361-K881-Z102-4-7619
Connecting the Server to the Line Voltage
1
1
2
2
51
Advertisement
Table of Contents
