[Startup Input Select]; Rs-232C] - Panasonic PT-DZ770E Operating Instructions Manual

[PROJECTOR SETUP] menu
z To delete a command already set, press the
<DEFAULT> button on the Step 6) screen, or select
[DELETE] on the Step 7) screen and press the
<ENTER> button.
z If multiple commands have been set for the same
time, they are executed in chronological order
starting from the smallest command number.
z The operating time will be the local time.(
z If an operation is executed with the remote control
or control panel of the projector or with a control
command before the command set in [SCHEDULE]
is executed, the command set with this function
may not be executed.

[STARTUP INPUT SELECT]

Set the input signal when the power is turned on.
1) Press ▲▼ to select [STARTUP INPUT
SELECT].
2) Press ◀▶ to switch [STARTUP INPUT
SELECT].
▶
z The setting will change as follows each time
you press the button.
[LAST USED]
[HDMI]
[DVI-D]
[LAST USED] Keep the input selected last time.
Set the input when the power is
[RGB1]
turned on to RGB1.
Set the input when the power is
[RGB2]
turned on to RGB2.
Set the input when the power is
[VIDEO]
turned on to VIDEO.
Set the input when the power is
[S-VIDEO]
turned on to S-VIDEO.
Set the input when the power is
[DVI-D]
turned on to DVI-D.
Set the input when the power is
[HDMI]
turned on to HDMI.
70 - ENGLISH

[RS-232C]

Set the communication conditions of the <SERIAL
IN>/<SERIAL OUT> terminal.
1) Press ▲▼ to select [RS-232C].
2) Press the <ENTER> button.
page 73)

3) Press ▲▼ to select an item.
■ To set the communication
4) Select [(IN) BAUDRATE] in Step 3).
5) Press ◀▶ to switch [(IN) BAUDRATE].
6) Press ▲▼ to select [(IN) PARITY].
[RGB1]
7) Press ◀▶ to switch [(IN) PARITY].
[RGB2]
[VIDEO]
■ To set the communication
[S-VIDEO]
4) Select [(OUT) BAUDRATE] in Step 3).
5) Press ◀▶ to switch [(OUT)
6) Press ▲▼ to select [(OUT) PARITY].
7) Press ◀▶ to switch [(OUT) PARITY].
■ To set the response
4) Select [RESPONSE(ID ALL)] in Step 3).
5) Press ◀▶ to switch [RESPONSE(ID
▶
z The [RS-232C] screen is displayed.
▶
condition of the <SERIAL IN>
terminal
▶
z The setting will change as follows each time
you press the button.
[9600] [19200]
▶
z The setting will change as follows each time
you press the button.
[NONE] [EVEN]
▶
condition of the <SERIAL OUT>
terminal
BAUDRATE].
▶
z The setting will change as follows each time
you press the button.
[9600] [19200]
▶
z The setting will change as follows each time
you press the button.
[NONE] [EVEN]
▶
ALL)].
[38400]
[ODD]
[38400]
[ODD]