Error Information Page - Panasonic PT-DZ770E Operating Instructions Manual

[NETWORK] menu

■ Error information page

▶
When [Error (Detail)] is displayed in the self-diagnosis display of the [Projector status] screen, click it to
display the error details.
▶
z The projector may go into the standby status to protect the projector depending on the contents of the error.
▶
zDescription of problem occurrence [FAILED]:
Parameter
[MAIN CPU BUS]
[FAN]
[INTAKE AIR TEMPERATURE]
[OPTICS MODULE TEMPERATURE]
[AROUND LAMP TEMPERATURE]
[LAMP1 REMAIN TIME]
[LAMP2 REMAIN TIME]
[LAMP1 STATUS]
[LAMP2 STATUS]
[SHUTTER]
[INTAKE AIR TEMP.SENSOR]
[OPTICS MODULE TEMP.SENSOR]
[AROUND LAMP TEMP.SENSOR]
[BATTERY]
[COLOR WHEEL]
[COVER OPEN]
[FILTER UNIT]
[AIR FILTER]
88 - ENGLISH
There is a problem with the microcomputer circuitry. Consult your
dealer.
There is a problem with the fan or the fan drive circuit. Consult your
dealer.
The air intake temperature is too high. It may be used in an operating
environment where the temperature is high, such as near a heating
appliance.
The temperature inside the projector is high. It may be used in an
operating environment where the temperature is high, such as near a
heating appliance.
The temperature around the lamp is high. The air exhaust port may
be blocked.
The usage time of the lamp has exceeded the specified time, and it is
time to replace the lamp.
The lamp has failed to turn on. Wait a while until the luminous lamp
cools off, and then turn on the power.
There is a problem with the shutter circuitry. Consult your dealer.
There is a problem with the sensor used to detect intake air
temperature. Consult your dealer.
There is a problem with the sensor used to detect temperature inside
the projector. Consult your dealer.
There is a problem with the sensor used to detect exhaust air
temperature. Consult your dealer.
Battery replacement is required. Consult your dealer.
There is a problem with the color wheel or the color wheel drive
circuit. Consult your dealer.
The lamp unit cover is not attached properly. Check the installation of
the lamp unit cover.( page 107)

The air filter unit is not attached. Check the connection of the air filter
unit.( page 105)

There are too much dust accumulated in the air filter unit.
Turn off the <MAIN POWER> switch to <OFF>(
the air filter.( page 104)

[OK]: operating properly
[FAILED]: a problem occurred
[WARNING]: warning
Description
page 38), and clean
