[Position] Menu; [Shift]; [Aspect]; The Picture Mode - Panasonic PT-DZ770E Operating Instructions Manual

[POSITION] menu

Select [POSITION] from the main menu, and
select the item from the sub-menu.
Refer to "Navigating through the menu"
( page 44) for the operation of the menu

screen.
z After selecting the item, press ▲▼◀▶ to set.

[SHIFT]

You can move the image position vertically or
horizontally if the image position projected on the
screen is shifted even when the relative position of the
projector and the screen is installed correctly.
1) Press ▲▼ to select [SHIFT].
2) Press the <ENTER> button.
▶
z The [SHIFT] screen is displayed.
3) Press ▲▼◀▶ to adjust the position.
■ For vertical (up and down) ▶
adjustment
Operation
The picture
Press ▲ .
position moves
up.
The picture
Press ▼ .
position moves
down.
■ For horizontal (right and left) ▶
adjustment
Operation
The picture
Press ▶ .
position moves to
the right.
The picture
Press ◀ .
position moves to
the left.
Adjustment
Adjustment
[POSITION] menu

[ASPECT]

You can switch the aspect ratio of the image.
The aspect ratio is switched within the screen range
selected in [SCREEN SETTING]. Set [SCREEN
SETTING] first.( page 60)

1) Press ▲▼ to select [ASPECT].
2) Press ◀▶ or the <ENTER> button.
▶
z The [ASPECT] individual adjustment screen is
displayed.
3) Press ◀▶ to switch [ASPECT].
▶
z The setting will change as follows each time
you press the button.
[VID AUTO] *1
[S1 AUTO]
[DEFAULT]
[HV FIT]
[V FIT]
[H FIT] [4:3]
*1: For video signal and S video (NTSC) signal input only
*2: For S video (NTSC) signal input only
*3: For RGB (480i or 480p) signal input only
■ [DEFAULT] ▶
Pictures are displayed without changing the
aspect ratio of the input signals.
■ [VID AUTO] ▶
The projector identifies the video ID (VID)
embedded in the image signals and displays the
image by automatically switching the screen sizes
between 4:3 and 16:9. This function is effective for
NTSC signals.
■ [S1 AUTO] ▶
The projector identifies the S1 signal, and displays
the image by automatically switching the screen
sizes between 4:3 and 16:9. This function is
effective for NTSC signals of S-VIDEO.
■ [VID AUTO(PRI.)] ▶
The projector identifies the above VID and S1
signals, and displays the image by automatically
switching the screen sizes between 4:3 and 16:9
in accordance with VID if it detects VID, or S1
signal if it does not detect VID. This function is
effective for NTSC signals of S-VIDEO.
■ [AUTO] ▶
The projector identifies the video ID (VID)
embedded in the image signals and displays the
image by automatically switching the screen sizes
between 4:3 and 16:9. This function is effective for
480i/480p signals.
[VID AUTO(PRI.)]
*2 *2
[AUTO] *3
[THROUGH]
[16:9]
ENGLISH - 51